Back to My Harley

Installation of Wild1's #575 Handlebars

I was asked by a couple of people to document the installation of my Wild1's #575 handlebars on my ElectraGlide Ultra Classic. Today was the perfect day. It's cool, rainy, and wet . . .perfect for motorcycle customization in my workshop.

The following is a sequence of thumnails that link to pictoral documentation of the job. It wasn't nearly as difficult as I had feared. Total time from roll-in to roll out: 3 hours, 22 minutes.

The following is simply a documentation of my handlebar installation. It is not a step-by-step instruction set and is not authorized by any person or vendor. When working on your own motorcycle, proceed at your own risk. Using this website is no guarantee of success or safety.



Getting Ready
Batwing
Hidden Screws

Exposed

Tricky Release

Success

Console

Clipping Ties

Controls

Brake Shim

Remove Bars

Compare Clamp

No Bars
Control Wiring
Documentation

Connector

Clamp Assembly

Clamp Alignment

Connector Relocation

Old and New

Internal Wiring

Right Connector

Brakeline

Throttle Assy

Clutch Cable
Left Grip
See!

Switch Block

Finished!