Threading
the Wiring
Previous
| Home | Next
Stringing the wiring
through the bars is easy, taking only a few minutes. I used a spring hook
to gently grab and pull each wire through the center hole. Then, it was
simply a matter of simultaneously pushing and pulling on each of the cables
until they were in the right positions. I've done this several times in
the past on different bikes. No lubricant was required.
Also, notice the
ground wire lug installed under the left-hand riser and the compensating
washer under the right-hand riser.
I just noticed
that the slight clearance between the riser clamp and the bottom of the
radio is pictured here. It's 1/8" or less.
|